QUANTUM ERROR CORRECTION COMPREMENTARY SERIAL

If two bits are interchanged, then it cannot detect the errors.

It can only detect single-bit errors which are very rare.

This technique generates the total number of 1s even, so it is known as even-parity checking.

At the receiving end, the parity bit is calculated from the received data bits and compared with the received parity bit.

If the number of 1s bits is odd, then parity bit 1 is appended and if the number of 1s bits is even, then parity bit 0 is appended at the end of the data unit.

Therefore, the total number of transmitted bits would be 9 bits.

In this technique, a redundant bit is also known as a parity bit which is appended at the end of the data unit so that the number of 1s becomes even.

Single Parity checking is the simple mechanism and inexpensive to detect the errors.

The most popular Error Detecting Techniques are: The number of affected bits depends on the duration of the noise and data rate.

QUANTUM ERROR CORRECTION COMPREMENTARY SERIAL

The duration of noise in Burst Error is more than the duration of noise in Single-Bit.īurst Errors are most likely to occurr in Serial Data Transmission. The Burst Error is determined from the first corrupted bit to the last corrupted bit. The two or more bits are changed from 0 to 1 or from 1 to 0 is known as Burst Error. For example, if eight wires are used to send the eight bits of a byte, if one of the wire is noisy, then single-bit is corrupted per byte.

Single-Bit Error mainly occurs in Parallel Data Transmission.

For example, Sender sends the data at 10 Mbps, this means that the bit lasts only for 1 ?s and for a single-bit error to occurred, a noise must be more than 1 ?s. Single-Bit Error does not appear more likely in Serial Data Transmission. In the above figure, the message which is sent is corrupted as single-bit, i.e., 0 bit is changed to 1. The only one bit of a given data unit is changed from 1 to 0 or from 0 to 1. Types Of ErrorsĮrrors can be classified into two categories: An Error is a situation when the message received at the receiver end is not identical to the message transmitted.

When data is transmitted from one device to another device, the system does not guarantee whether the data received by the device is identical to the data transmitted by another device.

Quantum error correction comprementary